SunHeater Solar Heaters

A Sunheater solar pool heating system will raise the temperature of your pool water by up to 10° F (6° C). or more. It is lightweight, durable and easy to install. Water simply flows through the SunHeater's many tubes via your existing pool pump where it is heated by the sun and returned to your pool.
The system can be installed on the roof of your house, shed or cabana, mounted to a rack, or simply placed on the ground. Systems are available to suit all sizes of aboveground and inground pools.

Using your existing pool pump, water circulates through the solar collectors, is heated by the sun and returned to the pool through the existing fitting.

• Raises Pool Water Temperature 10° F (6° C) or More
• Simple Do-It-Yourself Installation
• Tube on Web Design for Maximum Exposure to Sun's Rays
• No Fuel or Electricity Bills or Expensive Installation of Equipment and Connections
• Small Panel Height Easy to Merchandise and Ship
• Easy to Drain for Winterizing

Included:

• 2 Elbows/Hose-Connector Adapters
• 2 End Caps
• Connector Hose For Second Collector
• 2 Stainless Steel Clamps
• 1 Roll of Teflon Tape

Using your existing pool pump, water circulates through the solar collectors, is heated by the sun and returned to the pool through the existing fitting.

• Raises Pool Water Temperature 10° F (6° C) or More
• Simple Do-It-Yourself Installation
• 4' x 20' of Solar - 80,000 BTUs Daily!
• Uses Existing Pool Pump
• Tube on Web Design for Maximum Exposure to Sun's Rays
• Will Lower or Even Eliminate Fuel or Electricity Bills
• As Few as Two Panels Required, Depending on Pool Size
• Easy to Drain for Winterizing

• 2 - 2' x 20' Polypropylene Collectors
• 10 Mounting Brackets
• 10 - #14 Screws
• 4 Rubber Connector Hose
• 8 Stainless Steel Clamps
• 1 Roll of Teflon™ Tape

Mounting Hardware

• 1 - 1.5" Diverter Valve
• 1 - 3.75 " Hose
• 2 Pipe Adapters
• 1 End Cap
• 1 Vacuum Relief End Cap
• 5 Stainless Steel Mounting Brackets
• 5 - 2" #14 Stainless Steel Screws
• 100' Web Strap (Mounts up to 4 - S601 boxes)
• 1 Spring Check valve
• 3 Stainless Steel Hose Clamps

Safely Mounts Solar Collectors to a Roof or Rack:

• 5 - 6' Straps of Black Webbing
• 15 Stainless Steel Mounting Brackets
• 15 - #14 Stainless Steel Screws

Allows Control of Water through Collector(s) or Directly Back to Pool:

• 1 - 1.5" Unibody Valve
• 2 - 1.5" Tees
• 1 - 1.5" FPT Nipple
• 4 - 1.5" x 1.25" Adapters